All subjects
Research & Development

WSU researchers uncover key Fischer-Tropsch insight

WSU researchers uncover key Fischer-Tropsch insight
The Fischer-Tropsch (FT) process is used in industry to convert coal, natural gas, or biomass to liquid fuels (photo courtesy WSU).

Researchers at Washington State University (WSU) in the United States (US) have made a "fundamental discovery" about the Fischer-Tropsch (FT) process, a catalytic reaction used in industry to convert coal, natural gas, or biomass to liquid fuels, could someday allow for more efficient fuel production.

An error occurred

You are logged in as subsbriber at Bioenergy International, but something is wrong.

On your profile you can see what subscriptions you have access to and more information.

Is some of the information wrong – please contact our customer service.

Please reload the page

We could not ascertain if you are logged in or not. Please reload this page.
Bioenergy International premium

Do you want to read the whole article?

Only logged in payed subscribers can read all contents on
As an subscriber you get:
  • Six editions per year
  • Full access to all digital content
  • The E-magazine Bioenergy international
  • And more ...

The WSU researchers have discovered previously unknown self-sustained oscillations in the Fischer-Tropsch (FT) process.

They found that, unlike many catalytic reactions that have one steady state, this reaction periodically moves back and forth from a high to a low activity state.

The discovery, described in the article “An oscillating reaction to produce clean fuels” published in the journal Science, means that these well-controlled oscillatory states might be used in the future to enhance the reaction rate and the yields of desired products.

Usually, rate oscillations with large variations in temperature are unwanted in the chemical industry because of safety concerns. In the present case, oscillations are under control and mechanistically well understood. With such a basis of understanding, both experimentally and theoretically, the approach in research and development can be completely different — you really have a knowledge-based approach, and this will help us enormously, said corresponding author Norbert Kruse, Voiland Distinguished Professor in WSU’s Gene and Linda Voiland School of Chemical Engineering and Bioengineering.

Potential to fine-tune with designer catalysts

Although the Fischer-Tropsch process is commonly used for fuel and chemical production, researchers have had little understanding of how the complex catalytic conversion process works.

The process uses a catalyst to convert two simple molecules, hydrogen and carbon monoxide, into long chains of molecules — the hydrocarbons that are used widely in daily life.

While a trial-and-error approach has been used in research and development in the fuels and chemical industries for more than a century, researchers will now be able to design catalysts more intentionally and tune the reaction to provoke oscillatory states that could improve the catalytic performance.

Chance discovery

The researchers first came upon the oscillations by accident after graduate student Rui Zhang approached Norbert Kruse with a problem: he wasn’t able to stabilize the temperature in his reaction.

As they studied it together, they discovered the surprising oscillations.

That was pretty funny. He showed it to me, and I said, ‘Rui, congratulations, you have oscillations! And then we developed this story more and more, Norbert Kruse said.

The researchers not only discovered that the reaction develops oscillatory reaction states but why it does so.

As the temperature of the reaction goes up due to its heat production, the reactant gases lose contact with the catalyst surface and their reaction slows down, which reduces the temperature.

Once the temperature is sufficiently low, the concentration of the reactant gases on the catalyst surface increases and the reaction picks up speed again. Consequently, the temperature increases to close the cycle.

Theoretical modeling and lab demo match

For the study, the researchers demonstrated the reaction in a lab employing a frequently used cobalt catalyst, conditioned by adding cerium oxide, and then modeled how it worked.

Co-author Pierre Gaspard at the Université Libre de Bruxelles (ULB), Belgium developed a reaction scheme and theoretically imposed periodically changing temperatures to replicate the experimental rates and selectivities of the reaction.

It’s so beautiful that we were able to model that theoretically. The theoretical and the experimental data nearly coincided, said corresponding author Yong Wang, Regents Professor in WSU’s Voiland School who also co-advised Zhang.

Professor Norbert Kruse has been working on oscillatory reactions for more than 30 years. The discovery of the oscillatory behavior with the Fischer-Tropsch reaction was very surprising because the reaction is mechanistically extremely complicated.

We have a lot of frustration sometimes in our research because things are not going the way you think they should, but then there are moments that you cannot describe. It’s so rewarding, but ‘rewarding’ is a weak expression for the excitement of having had this fantastic breakthrough, Professor Kruse said.

The work was supported by the Chambroad Chemical Industry Research Institute Co., Ltd, China, the National Science Foundation (NSF), and the US Department of Energy’s (DOE) Basic Energy Sciences Catalysis Science program.

Most read on Bioenergy International

Get the latest news about Bioenergy

Subscribe for free to our newsletter
Sending request
I accept that Bioenergy International stores and handles my information.
Read more about our integritypolicy here